Hallo zusammen,
wir hatten immer mal wieder Computer, wo sich automatisch die MAC Adresse beim Inventarisieren auf z.B. die WLAN MAC geändert hat. Mittlerweile konnte das Verhalten durch die Einstellung im DBUtil -> Empirum Inventory -> Übernahme Inventory Computer -> Nie, abgestellt werden.
Jedoch haben wir einige Rechner mit mehreren LAN Netzwerkkarten und hier tritt folgendes verhalten ein.
Man stellt die MAC Adresse auf die gewünschte Karte ein, installiert den Rechner über PXE, nach der Betriebssystem Installation wird das Computerobjekt automatisch geändert und es steht eine andere MAC Adresse drin, außerdem wird automatisch der Haken "PXE fähig" entfernt.
Hat jemand eine Idee, was noch zusätzlich deaktiviert werden muss, damit keine Automatische MAC Änderung stattinden kann?
viele Grüße
Daniel
Automatische MAC Änderung
-
- Posts: 10
- Joined: 15. Jul 2013, 10:33
- Contact:
-
- Moderator
- Posts: 7965
- Joined: 13. Dec 2004, 23:10
- Location: Adendorf/Lüneburg
Re: Automatische MAC Änderung
Spricht etwas gegen das normale Vorgehen die WLAN-Adapter auf "Exclude" zu setzen in der Inventory-Konfiguration?
Hendrik Ambrosius / Senior Presales Consultant
Mobile: +49 172 408 4447 | hendrik.ambrosius@matrix42.com
Matrix42 GmbH | Elbinger Straße 7 | 60487 Frankfurt am Main | Germany | www.matrix42.com
Disclaimer: I participate in this forum on a voluntary basis. Views expressed are not necessarily those of Matrix42 or of the support team.
Mobile: +49 172 408 4447 | hendrik.ambrosius@matrix42.com
Matrix42 GmbH | Elbinger Straße 7 | 60487 Frankfurt am Main | Germany | www.matrix42.com
Disclaimer: I participate in this forum on a voluntary basis. Views expressed are not necessarily those of Matrix42 or of the support team.
Who is online
Users browsing this forum: No registered users and 8 guests