Hi,
I`ll try to explain the problem as best I can:
We just updated our V12 Matrix server to V14.
On our PC`s we have the start order defined as 1. Lan, 2. HD, etc...
Before the update a PC was switched on and it looked for a DHCP server
DHCP........ within a few seconds the Matrix server responded with a message like" Configured by emperium...IP XXXXXX...etc". The PC then started form the HD and all was fine.
Sine the update this doesnt happen. The DHCP polling starts: DHCP................................................. continues until a timeout and then th PC boots from the HD. This can take several minutes unless we stop it by pressing the ESC key.
So my question is: What service or whatever needs to be configured so it works right again?
Thanks in advance.
dhcp after update from V12 to V14
Moderator: MVogt
Re: dhcp after update from V12 to V14
hi,
after the update , you reinstall all Empirum-Services ?
if possible the PXE-server runs in the wrong Mode ?
your can use the sysinternal tool debugview to track the Communication of the pxe service with database.
cYa
after the update , you reinstall all Empirum-Services ?
if possible the PXE-server runs in the wrong Mode ?
your can use the sysinternal tool debugview to track the Communication of the pxe service with database.
cYa
Thomas Hahn
Technical Account Manager
Matrix42 AG
Email: thomas.hahn[at]matrix42.com
http://www.matrix42.de
Skype: thahn42
ICQ: IO25IGO8
Disclaimer: I participate in this forum on a voluntary basis. Views expressed are not necessarily those of matrix42 AG.
Technical Account Manager
Matrix42 AG
Email: thomas.hahn[at]matrix42.com
http://www.matrix42.de
Skype: thahn42
ICQ: IO25IGO8
Disclaimer: I participate in this forum on a voluntary basis. Views expressed are not necessarily those of matrix42 AG.
Re: dhcp after update from V12 to V14
Hi and thanks for the reply.
Yes the services were reinstalled after the update.
The PXE service is currently running in: PXE/DHCP mode.
I`ll try to log the communication.
Yes the services were reinstalled after the update.
The PXE service is currently running in: PXE/DHCP mode.
I`ll try to log the communication.
-
- Moderator
- Posts: 7962
- Joined: 13. Dec 2004, 23:10
- Location: Adendorf/Lüneburg
Re: dhcp after update from V12 to V14
Are you sure you want to run the service in PXE/DHCP mode?
That means you have NO DHCP-server in your environment => Empirum will only answer to client where you entered a static IP address and will provice the dhcp lease as well.
Is that true?
That means you have NO DHCP-server in your environment => Empirum will only answer to client where you entered a static IP address and will provice the dhcp lease as well.
Is that true?
Hendrik Ambrosius / Senior Presales Consultant
Mobile: +49 172 408 4447 | hendrik.ambrosius@matrix42.com
Matrix42 GmbH | Elbinger Straße 7 | 60487 Frankfurt am Main | Germany | www.matrix42.com
Disclaimer: I participate in this forum on a voluntary basis. Views expressed are not necessarily those of Matrix42 or of the support team.
Mobile: +49 172 408 4447 | hendrik.ambrosius@matrix42.com
Matrix42 GmbH | Elbinger Straße 7 | 60487 Frankfurt am Main | Germany | www.matrix42.com
Disclaimer: I participate in this forum on a voluntary basis. Views expressed are not necessarily those of Matrix42 or of the support team.
Who is online
Users browsing this forum: No registered users and 6 guests