Hallo,
wenn ich bei der Installation bestimmte Registryschlüssel löschen will, kann man das ja normalerweise mit Reg:Product und einem vorangestelltem - bewerkstelligen.
Ich möchte aber die Schlüssel nur löschen, wenn eine bestimmte Bedingung erfüllt ist. Wie kann man das bewerkstelligen?
Gruß
S.Krasselt
Registryschlüssel bei Installation löschen
-
- Posts: 63
- Joined: 13. Dec 2004, 15:42
- Contact:
-
- Posts: 876
- Joined: 17. Dec 2004, 12:29
- Contact:
ein Then "Reg:This" EndIf setze ich mal voraus
Visit my Blog: "DiEW - Das inoffizielle Empirum Weblog" (http://www.diew.eu)
Martin Niemann
Manager Support (Service Management)
Disclaimer: I participate in this forum on a voluntary basis. Views expressed are not necessarily those of matrix42 AG or of the support team.
Martin Niemann
Manager Support (Service Management)
Disclaimer: I participate in this forum on a voluntary basis. Views expressed are not necessarily those of matrix42 AG or of the support team.
-
- Posts: 876
- Joined: 17. Dec 2004, 12:29
- Contact:
es ist laut Handbuch syntaktisch so vorgeschrieben. Daran sollte man sich halten, da ein "Bugfix" manchmal verherrende Folgen haben kann, wenn man es mal nicht befolgt hat, sondern sich auf einen nicht "funktionierenden Syntaxfehler" verlässt.
Visit my Blog: "DiEW - Das inoffizielle Empirum Weblog" (http://www.diew.eu)
Martin Niemann
Manager Support (Service Management)
Disclaimer: I participate in this forum on a voluntary basis. Views expressed are not necessarily those of matrix42 AG or of the support team.
Martin Niemann
Manager Support (Service Management)
Disclaimer: I participate in this forum on a voluntary basis. Views expressed are not necessarily those of matrix42 AG or of the support team.
Who is online
Users browsing this forum: No registered users and 8 guests